Skip to main content

Week 3


Plans:
Changed alien launch mechanism to spring activation rather than a motor activation


Start 3D print design by creating CAD of alien head and jaw mechanism
Head of alien
Jaw of alien







Latex molding research and then bought the latex

Sound board research
https://www.youtube.com/watch?v=b1CdC5gzTxY

Created and imported audio file using audacity


Labels:

Comments

Post a Comment

Popular posts from this blog

Week 7

Plans: assemble alien spine rings to pvc pipe in wooden container paint alien skin set up another speaker to make the alien louder work on ratchet winch system sand down hex shaft for winch system set up red led eyes Winch: how to tie a constrictor knot:  https://www.youtube.com/watch?v=r2XqvsnWiu8 how to wire the stepper motor:  https://www.youtube.com/watch?v=cYIL5gxRogM -get an easydriver Audio: Spring mechanism:
Post a Comment
Read more

Week 10

Plans: Assemble audio, motor, and servos all to one bread board and arduino uno drill holes for audio to play through adjust latex sizing for alien add stopper to alien figure out winch system Results: Assembled all parts to one arduino uno, but had to scrap winch idea The alien will only pop up, but will not go back into the box again
Post a Comment
Read more