Skip to main content

Week 4

Plans:
start building the box for the alien, possibly using laser cutting
Research servo linkages for the swaying motion of alien
Buy servo linkages
Experiment with a slinky for the body of the alien

Sherry:
start latex molding/experimenting
wire up speaker system https://www.youtube.com/watch?v=9T-X2b4bsWc

Shawn:
construction of the box

Rj:
3D printing
CAD the slinky backbone

Yelnur:
Pseudo code for:
Labels:

Comments

Post a Comment

Popular posts from this blog

Week 7

Plans: assemble alien spine rings to pvc pipe in wooden container paint alien skin set up another speaker to make the alien louder work on ratchet winch system sand down hex shaft for winch system set up red led eyes Winch: how to tie a constrictor knot:  https://www.youtube.com/watch?v=r2XqvsnWiu8 how to wire the stepper motor:  https://www.youtube.com/watch?v=cYIL5gxRogM -get an easydriver Audio: Spring mechanism:
Post a Comment
Read more

Week 9

Plans: Assemble winch system install red LED eyes in alien Add alien skin to the skeleton Add all the code together Work on stopper for alien Fritzing for alien body swaying: Fritzing for alien jaw:
Post a Comment
Read more

Week 10

Plans: Assemble audio, motor, and servos all to one bread board and arduino uno drill holes for audio to play through adjust latex sizing for alien add stopper to alien figure out winch system Results: Assembled all parts to one arduino uno, but had to scrap winch idea The alien will only pop up, but will not go back into the box again
Post a Comment
Read more